The REXI gas pressure regulators Series is a direct-acting pressure regulator with balanced plug, for low, medium and high pressures. Suitable for non-corrosive gases; thanks to the concept of a balanced plug, you can achieve a high flow rate coefficient, highly accurate (even at maximum flow rates), a lock up zone and relatively low lock up pressure, no internal leakage at zero flow rate and reduced response times.
The constancy of the regulated pressure and its accuracy, even with significant changes in the upstream pressure and/ or flow rate, make the REXI Series regulator especially suitable for power distribution networks in civil and industrial plants. The basic version of the REXI Series regulator is made according to European Standard EN 334, as a Fail to Open regulator.
The shut-off device can be calibrated for pressure increase, Over Pressure Shut-Off (OPSO) and/or for pressure decrease, Under Pressure Shut-Off (UPSO). The two intervention modes can be calibrated independently by dedicated calibration springs: one spring for the maximum pressure intervention and the second spring for the minimum pressure intervention. REXI series can be supplied also without Slam Shut valve.
The REXI Series can be equipped with an incorporated relief valve that discharges the gas into the atmosphere when the regulator outlet pressure exceeds the set value. When the outlet pressure returns to below the set value, the relief valve closes again.
Dimensions RG040-LP-RV-H gas governor
Technical drawing RG040-LP-RV-H pressure regulator
Flow rates RG040-LP-RV-H pressure regulator
Thumb | File information |
Gas-pressure-regulator-RG040-LP-RV-H-REXI-Geca.pdf File Size6.45MB Downloaded: 100 |
General | |
Maximum operating pressure | 10 bar |
Pressure setting range | 15-110 mbar |
Nominal diameter | 1" 1/2 - 1" 1/2 |
Tags: pressure regulator, governor, gas train, high pressure